To Knuckle

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

All views are typical.

Fig 1: Drag Link Adjuster Sleeve, Nut & Bolt

Courtesy of CHRYSLER GROUP, LLC

Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Loosen the nut/bolt (2) on the drag link adjuster sleeve (1) as necessary.

Fig 2: Drag Link/Tie Rod To Knuckle Nut & Cotter Key
Courtesy of CHRYSLER GROUP, LLC
Remove the cotter key (1) and the drag link/tie rod to knuckle nut (2).
Remove the drag link end (3) from the knuckle (5) with (special tool #10390, Separator, Tie Rod).
Remove the drag link end (3) from the adjuster sleeve.