To Pitman Arm
WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
All views are typical. 2500 shown in illustration, others similar.
CAUTION:
Verify that equal number of thread engagement exists on both ends of adjuster sleeve and that the adjuster sleeve clamps cover the threaded ends.
NOTE:
Prior to installing tapered end suspension components, clean male and female surfaces with brake clean.
- Install the drag link end (4) to the adjustment sleeve (3) and to the pitman arm.
- Install the drag link to pitman arm nut (5) and tighten to specifications Refer to LINKAGE, LINK AND COIL, SPECIFICATIONS .
- Remove the supports and lower the vehicle. Center the steering wheel and adjust the toe Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE
.NOTE:
Position the clamp on the adjustment sleeve so retaining bolt is located on the bottom side of the sleeve.
- After adjustment, tighten the tie rod adjustment sleeve clamp bolts to specifications, Refer to LINKAGE, LINK AND COIL, SPECIFICATIONS .