Outer Tie Rod End
WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Do not twist the boot anytime during removal or installation.
- Loosen the jam nut (3).
- Remove the outer tie rod end nut from the ball stud.
- Separate the tie rod ball stud (1) from the knuckle with Ball Joint Remover (special tool #9360, Remover, Ball Joint) (2).
- Unthread the outer tie rod end (1) from the inner tie rod.