LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 338 (Steering System - 2500 Hd & 3500 Hd) >> Gear, Independent Front Suspension >> Bushing, Steering Gear >> Removal >> Removal

Bushing, Steering Gear: Removal: Removal

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering gear. Refer to GEAR, INDEPENDENT FRONT SUSPENSION, REMOVAL  or GEAR, LINK AND COIL, REMOVAL .
    CAUTION:

    Do not overtighten the vise on the gear case.

  2. Mount the steering gear in a soft jawed vise.
    NOTE:

    If the bushings are seized a brass punch can be used to remove the bushings from the gear using care not to strike the gear.

  3. Remove the front mounting bushings.
  4. Remove the rear mounting bushings.
  5. Remove the steering gear from the vise and place it on the bench.
scientia non olet · About LEMON Manuals