LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 337 (Front Suspension & Wheel Alignment - 2500 Hd & 3500 Hd) >> Front, Link And Coil >> Link, Stabilizer Bar >> Removal >> Stabilizer Link With Disconnecting Stabilizer Bar

Stabilizer Link With Disconnecting Stabilizer Bar

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Stabilizer Link, Nuts, And Stabilizer Bar
GC0107552Courtesy of CHRYSLER GROUP, LLC
  1. Raise and support the vehicle.
  2. Hold the stabilizer link (1) shafts with a wrench and remove the link nuts (3) at the stabilizer bar (2).
    Fig 2: Identifying Stabilizer Link, Axle Brackets & Puller
    GC0107553Courtesy of CHRYSLER GROUP, LLC
  3. Remove the stabilizer bar link nuts from the axle brackets (2).
  4. Remove the links (1) from the axle brackets (2) with Puller (special tool #9360, Remover, Ball Joint) (3).
scientia non olet · About LEMON Manuals