LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 337 (Front Suspension & Wheel Alignment - 2500 Hd & 3500 Hd) >> Front, Link And Coil >> Link, Stabilizer Bar >> Installation >> With Disconnecting Stabilizer Bar

With Disconnecting Stabilizer Bar

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Stabilizer Link, Nuts, And Stabilizer Bar
GC0107552Courtesy of CHRYSLER GROUP, LLC
  1. Install links (1) to the axle bracket (5) and tighten nut (4) to specifications. Refer to FRONT, LINK AND COIL, SPECIFICATIONS .
  2. Install links (1) and nuts (3) to the stabilizer bar (2). Hold the link shaft with a wrench and tighten the nuts to specifications. Refer to FRONT, LINK AND COIL, SPECIFICATIONS .
  3. Remove the supports and lower the vehicle.
scientia non olet · About LEMON Manuals