LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 337 (Front Suspension & Wheel Alignment - 2500 Hd & 3500 Hd) >> Front, Link And Coil >> Knuckle, Steering >> Removal >> 2500, 3500

2500, 3500

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the hub bearing. Refer to HUB AND BEARING, REMOVAL .
  2. Remove tie-rod or drag link end from the steering knuckle arm.
  3. Remove the wheel speed sensor. Refer to SENSOR, WHEEL SPEED, FRONT, REMOVAL .
  4. Loosen the upper ball stud nut.Do not remove the nut at this time. 
  5. Remove the lower ball joint nut.
    Fig 1: Identifying Lower Ball Joint And Steering Knuckle
    GC0107544Courtesy of CHRYSLER GROUP, LLC
  6. Separate the lower ball joint (4) using Ball Joint Press (special tool #C-4150A, Press, Ball Joint) (3).
  7. Remove the upper ball joint nut.
  8. Remove the steering knuckle (2).
scientia non olet · About LEMON Manuals