4500 And 5500
WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The upper ball joints screw in and out (they are not pressed in).
- Remove the wheel and tire assembly.
- Support the lower part of the steering knuckle.
- Remove the upper ball joint nut (1).
- Disconnect the wheel speed sensor wire from the bracket (3).
- Install a 60 mm socket (1) and unscrew the upper ball joint (2) from the steering knuckle.
- Remove the wheels speed sensor wire bracket (3).