Diagnostic Test
WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
- ACTIVE DTC NOTE:
Diagnose all CAN communication DTCs before continuing.
- Ignition on, engine not running.
- With a scan tool, view DTCs.
Is the status Active for this DTC?
Yes
- Go To 2
No
- Perform the Stored Lost Communication DTCs diagnostic procedure. Refer to DIAGNOSIS AND TESTING .
- COMMUNICATION DTCS PRESENT IN THE TRANSFER CASE CONTROL MODULE
- With a scan tool check for DTCs in the Transfer Case Control Module / AWD.
Are there any CAN bus DTCs active in the Transfer Case Control Module at this time?
Yes
- Perform the U0102-Lost Communication with Transfer Case Control Module/AWD diagnostic procedure. Refer to DTC INDEX - 1500 .
No
- Replace and program the Powertrain Control Module (PCM) in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
- Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .
- With a scan tool check for DTCs in the Transfer Case Control Module / AWD.