Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

PROGRAM ALL FOBIKS
NOTE:
All FOBIKs that are to be used in this vehicle must remain on the front seat near the console during programming.
1. With the scan tool, select "Misc. Functions", "Program Ignition FOBIKs" and follow the instructions on the screen.
2. Program all FOBIKs that are used with this vehicle.
3. Try each FOBIK that was programmed.
  Do all FOBIKs operate properly?
  
  Yes
  - Test complete.
  No
  - With the scan tool perform the "RFH", "Reset ECU" and repeat this test from the beginning.