Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go To 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK THE (F982) FUSED IGNITION (RUN/ACC) CIRCUIT FOR AN OPEN

Fig 1: Measuring Voltage Between Fused Ignition Switch Output Circuit & Ground In Rain Sensor Harness Connector
Courtesy of CHRYSLER GROUP, LLC
1. Turn the ignition off.
2. Disconnect the Light Rain Sensing Module harness connector.
3. Turn the ignition on.
4. Using a 12-volt test light connected to ground, check the (F982) Fused Ignition (Run/Acc) circuit.
  Does the test light illuminate brightly?
  
  Yes
  - Go To 3
  No
  - Repair the open or short to ground in the (F982) Fused Ignition (Run/Acc) circuit.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK THE (Z911) GROUND CIRCUIT FOR AN OPEN

Fig 2: Identifying Ground Circuit Terminal At Rain Sensor Connector
Courtesy of CHRYSLER GROUP, LLC
1. Turn the ignition off.
2. Using a 12-volt test light connected to 12-volts, check the (Z911) Ground circuit.
  Does the test light illuminate brightly?
  
  Yes
  - Go To 4
  No
  - Repair the open in the (Z911) Ground circuit.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK THE (D402) LIN BUS CIRCUIT FOR AN OPEN

Fig 3: Measuring Voltage Between LIN Bus Circuit And Ground At Rain Sensor Connector
Courtesy of CHRYSLER GROUP, LLC
1. Turn the ignition on.
2. Measure the voltage between ground and the (D402) LIN BUS circuit.
  Is the voltage above 5.0 volts?
  
  Yes
  - Replace the Light Rain Sensing Module in accordance with the service information.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Repair the open in the (D402) LIN Bus circuit.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .