Diagnostic Test
WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
- PCM FROM ANOTHER VEHICLE INSTALLED NOTE:
This DTC is set when a PCM from another vehicle is installed into the current vehicle.
Has another PCM been installed?
Yes
- Confirm the PCM was replaced in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
- Perform the POWERTRAIN VERIFICATION TEST. Refer to appropriate diagnostic information .
No
- Go To 2
- OTHER CAN C MODULES SET VIN MISMATCH
- Turn the ignition on.
- With the scan tool, read DTCs.
Is the VIN Mismatch DTC set in other CAN C modules?
Yes
- Replace the PCM in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
- Perform the POWERTRAIN VERIFICATION TEST. Refer to appropriate diagnostic information .
No
- Replace the BCM in accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .