LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Steering System) >> Gear, Independent Front Suspension >> BUSHING, Steering Gear >> Installation >> Installation

BUSHING, Steering Gear: Installation: Installation

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Coat all bushings with a thin rubber lubricate oil prior to installation.

NOTE:

A rubber mallet can be used to assist in the installation of the bushings once lubricated.

  1. Coat the rear bushings with a thin rubber lubricate oil then install the rear bushings using a rubber mallet to seat the bushings in the gear.
  2. Coat the front bushings with a thin rubber lubricate oil then install the front bushings using a rubber mallet to seat the bushings in the gear.
  3. Install the steering gear. Refer to Gear, Independent Front Suspension , Installation Gear, Link and Coil , Installation .
  4. Adjust the toe position (if necessary). Refer to Wheel Alignment , Standard Procedure .
scientia non olet · About LEMON Manuals