Diagnostic Test
WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
- VERIFY ACTIVE DTC
- Turn the ignition on.
- With the scan tool, read ORC DTCs.
Does the scan tool display an active B0095-49-RIGHT FRONTAL ACCELERATION SENSOR - INTERNAL ELECTRONIC FAILURE DTC or shows a setting history in stored?
Yes
WARNING:Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
- Replace the Right Front Impact Sensor in accordance with the Service Information. Refer to SENSOR, IMPACT, REMOVAL .
- Perform the RESTRAINT SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No (Did not set a active or stored DTC B0095-49- RIGHT FRONTAL SENSOR - INTERNAL ELECTRONIC FAILURE)
- Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to STANDARD PROCEDURE .
NOTE:
If the scan tool shows this DTC has a Stored history of setting then the right front impact sensor is to be replaced.
NOTE:
Make sure the battery is fully charged.