Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

VERIFY THE DTC IS ACTIVE
NOTE:
This DTC must be active for the results of this test to be valid. Check for a loose scan tool connection. Verify battery charger is installed and charge rate provides approximately 13.5 volts.
1. Ignition on, engine off.
2. With the scan tool, read DTCs and record on vehicle work order.
3. With the scan tool, erase DTCs.
4. With the scan tool, read the DTCs.
  Is the DTC active at this time?
  
  Yes
  - Replace the Electric Power Steering (EPS) Module in accordance with the Service Information. Refer to GEAR, INDEPENDENT FRONT SUSPENSION, REMOVAL .
  - Perform EPS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Test complete, the conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring harness and connectors.
  - Perform EPS VERIFICATION TEST. Refer to STANDARD PROCEDURE .