Inner Tie Rod End

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Outer Tie Rod End, Jam Nut, And Separator

Courtesy of CHRYSLER GROUP, LLC

Remove the outer tie rod end (1) Count the number of turns when removing, this will aid in setting the toe after installation. . Refer to END, TIE ROD, REMOVAL .
Remove the jam nut (3).

Fig 2: Boot & Clamps
Courtesy of CHRYSLER GROUP, LLC
Remove the clamps (1, 3) for the inner tie rod boot (2).
Remove the boot (2) and discard.

Fig 3: Inner Tie Rod Socket
Courtesy of CHRYSLER GROUP, LLC
Install (special tool #10087-9, Socket, Inner Tie Rod) (1) onto the Inner Tie Rod.

Fig 4: Inner Tie Rod Adapter Wrench
Courtesy of CHRYSLER GROUP, LLC
Install
(special tool #10087-2A, Adapter Wrench, Inner Tie Rod) (1) onto the Inner Tie Rod End.

Fig 5: EPS Steering Rack Holder
Courtesy of CHRYSLER GROUP, LLC
Install (special tool #10417, Holder, EPS Steering Rack) (1) onto the EPS Steering Rack on the non-screw side (Driver's Side) to prevent damage to the internal working of the EPS unit during loosening and remove the inner tie rod end.