LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Restraints (Service Information)) >> SENSOR, Impact >> Removal >> Side >> C-Pillar

SENSOR, Impact: Removal: Side: C-Pillar

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Side Impact Sensor
GC0088208Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
  2. Remove the trim from the inside of the lower C-pillar. Refer to PANEL, C-Pillar Trim, Lower , Removal .
  3. Disconnect the body wire harness connector (1) from the side impact sensor (2) connector receptacle.
  4. Remove the screw (3) that secures the sensor to the inner C-pillar.
  5. Remove the sensor from the inner C-pillar.
scientia non olet · About LEMON Manuals