C-Clutch Measurement
WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
- Using (special tool #8901A, Pressing Tool) (2) and (special tool #10429, Gauge, Force) (1) place the C-clutch (3) in a suitable arbor press (with the backing plate facing up).
- Apply 200 N (45 lbs.) of force to the C-clutch to compress the wave plate.
- With a suitable feeler gauge, measure the gap between the C-clutch backing plate and the C-clutch retainer.
- Refer to clutch clearance table for specs. Refer to CLUTCH SPECIFICATIONS . If clearance is not within specification a thinner or thicker selectable backing plate can be installed to achieve proper clearance.