LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 284 (8HP45 Automatic Transmission (Service Information) 1500) >> Seal, Output Shaft >> Removal >> Rear Wheel Drive

Rear Wheel Drive

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Propeller Shaft Flange, Rear Dust Seal & Rear Oil Seal
GC0152116Courtesy of CHRYSLER GROUP, LLC
  1. Remove the propeller shaft. Move propeller shaft to the right and tie up.
  2. Using a suitable punch, remove the staking from the nut.
  3. Remove the propeller shaft flange nut about using a 34 mm 12 point socket (3) and (special tool #C-3281, Holder, Flange) (2) to hold the flange (1).
  4. Remove the flange (1), and flange dust seal (2).
  5. Remove the output shaft seal (3) with suitable screw and slide hammer.
scientia non olet · About LEMON Manuals