Clutch Air Pressure Tests: Notes

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Clutch Air Pressure Test

Courtesy of CHRYSLER GROUP, LLC

Inoperative clutches can be located using a series of tests by substituting air pressure for fluid pressure using (special tool #10383, Plate, Clutch Pressure Test).

The clutches may be tested by applying air pressure to their respective passages. The valve body must be removed. To make air pressure tests, proceed as follows:

NOTE:

The compressed air supply must be free of all dirt and moisture. Use a pressure of 5-8 bar (73-116 psi).

Remove the oil pan and the valve body. Install (special tool #10383, Plate, Clutch Pressure Test) and tighten bolts to 6 N.m (50 in. lbs.). When testing is finished install valve body and tighten new bolts to 8 N.m (71 in. lbs.). Install the oil pan bolts and tighten to 10 N.m (89 in. lbs.). Fill the transmission or 8HP70 fluid and filter standard procedure. Refer to FLUID AND FILTER, STANDARD PROCEDURE .

NOTE:

If any clutch does not appear to be functioning with the air, add some 8HP trans fluid and try the test again. Some circuits will not operate without fluid.