LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Battery System (Service Information) 1500) >> Tray, Battery >> Removal >> Removal

Tray, Battery: Removal: Removal

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Battery Tray (Left Side) 1 Of 2
GC0083470Courtesy of CHRYSLER GROUP, LLC
  1. Remove the battery (3) from the battery tray. Refer to REMOVAL .
  2. Remove the Power Distribution Center (PDC) (5).
  3. Disconnect the wire harness retainers from the battery tray assembly.
  4. Disconnect the purge solenoid (6) from its mounting bracket.
  5. Remove the anti-lock brake controller (if equipped) retaining bolts and support the brake controller with mechanics wire. It is not necessary to completely remove the anti-lock brake control unit.
  6. Remove the left front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL .
    Fig 2: Removing/Installing Battery Tray (Left Side) 2 Of 2
    GC0083471Courtesy of CHRYSLER GROUP, LLC
  7. Mark the location of the cruise servo (3) (if equipped) and remove the retaining screws. Position the servo out of the way.
  8. Disconnect the left front fender ground wire.
  9. Remove the remaining battery tray retaining bolts (2).
  10. Remove the battery tray from the vehicle.
scientia non olet · About LEMON Manuals