LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 273 (Front Suspension & Wheel Alignment - 1500) >> Front, Independent Front Suspension >> Arm, Upper Control >> Installation >> Installation

Arm, Upper Control: Installation: Installation

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Control Arm, Pivot Bolts, And Flag Nuts
GC0083196Courtesy of CHRYSLER GROUP, LLC
  1. Position the control arm (1) into the frame brackets. Install bolt (3) and nut (2), and tighten to specifications. Refer to FRONT, INDEPENDENT FRONT SUSPENSION, SPECIFICATIONS .
    Fig 2: Steering Knuckle & Upper Ball Joint Nut
    GC0083197Courtesy of CHRYSLER GROUP, LLC
  2. Insert the ball joint in the steering knuckle (3) and tighten the upper ball joint nut (2) to specifications. Refer to FRONT, INDEPENDENT FRONT SUSPENSION, SPECIFICATIONS .
  3. Install the rotor to the hub.
  4. Install the disc brake caliper and adapter to the knuckle. Refer to ADAPTER, DISC BRAKE CALIPER, INSTALLATION .
  5. Install the wheel speed sensor wire to the upper control arm.
  6. Install the wheel and tire assembly. Refer to WHEELS, STANDARD PROCEDURE .
  7. Remove the support and lower vehicle.
  8. Perform a wheel alignment. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals