Converter, Catalytic: Installation: 3.6L
WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
- If removed, install the O2 sensors.
- Position new exhaust gasket (1) onto flange.
- Position the catalytic converter assembly (5) into vehicle.
- Install the upper bolts (2) at the catalytic converter to cylinder head. Tighten bolts to 23 N.m (17 ft. lbs.).
- Position the exhaust system for proper clearance with the frame and underbody parts. A minimum clearance of 25.4 mm (1.0 in.) is required.
- Tighten the front cross pipe to the catalytic converter flange nuts (2) to 30 N.m (22 ft. lbs.).
- Connect oxygen sensor (2) electrical connectors.
- If equipped, install skid plates.
- Lower vehicle.
- Start the vehicle and inspect for exhaust leaks. Repair exhaust leaks as necessary.