LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 268 (Communication - Non-DTC Based Diagnostics - 1500) >> Diagnosis And Testing >> No Response From ESM (Electronic Shift Module) - 8HP45/8HP70 >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. TEST FOR INTERMITTENT CONDITION 
    NOTE:

    Check for any TSB(s) related to the condition. If a TSB applies, perform the procedure outlined in the TSB before continuing.

    1. Turn the ignition on.
      NOTE:

      Make sure the battery voltage is between 10.0 and 16.0 volts.

    2. With the scan tool, read the module status.
      NOTE:

      Check the BCM for any active CAN hardware DTCs, perform DTC before proceeding.

      Does the scan tool indicate that the module is active on the bus?

      Yes 

      • The no response condition is not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring for chafed, pierced, pinched, and partially broken wires and the wiring harness connectors for broken, bent, pushed out, and corroded terminals.
      • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .

      No 

      • Go To  2
  2. CHECK THE (A195) FUSED B(+) CIRCUIT FOR AN OPEN OR SHORT 
    1. Turn the ignition off.
    2. Disconnect the Electronic Shift Module (ESM)/Shift Lever Assembly (SLA) harness connector.
    3. Using a 12-volt test light connected to ground, check the (A195) Fused B(+) circuit.

      Does the test light illuminate brightly?

      Yes 

      • Go To  3

      No 

      • Repair the open or short in the (A195) Fused B(+) circuit.
      • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  3. CHECK THE (Z911) GROUND CIRCUIT FOR AN OPEN 
    1. Using a 12-volt test light connected to 12-volts, check the (Z911) Ground circuit.

      Does the test light illuminate brightly?

      Yes 

      • Go To  4

      No 

      • Repair the open in the (Z911) Ground circuit.
      • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  4. CHECK THE (D429) AND (D430) CAN C BUS CIRCUITS FOR AN OPEN 
    1. Turn the ignition off.
    2. Disconnect the IP CAN C Star Connector C6 harness connector.
    3. Measure the resistance of the (D429) CAN C Bus (+) circuit between the IP CAN C Star Connector C6 harness connector and the Electronic Shift Module (ESM)/Shift Lever Assembly (SLA) harness connector.
    4. Measure the resistance of the (D430) CAN C Bus (-) circuit between the IP CAN C Star Connector C6 harness connector and the Electronic Shift Module (ESM)/Shift Lever Assembly (SLA) harness connector.

      Are the resistances below 5.0 Ohms?

      Yes 

      • Replace the Electronic Shift Module (ESM)/Shift Lever Assembly (SLA) in accordance with the Service Information.
      • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .

      No 

      • Repair the open in the (D430) or (D429) CAN C Bus circuit. Inspect the connector for damage.
      • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals