Section 266 (Charging System (Service Information) 1500): Generator: Removal: 3.6L

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Field Circuit, B+ Terminal Nut And Wire

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable
Unplug the field circuit (3) from generator.
Remove the B+ terminal nut (1) and wire (2).

Fig 2: Remove/Install Generator
Courtesy of CHRYSLER GROUP, LLC
Remove the serpentine belt. Refer to BELT, SERPENTINE, REMOVAL .
Remove the lower front generator mounting retainer (1).
Remove the upper bolt (1) and nut (2).
Remove the generator from the vehicle.