LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 265 (Heating & Air Conditioning (Service Information) 1500) >> Plumbing >> Line, A/C Suction >> Removal >> 4.7L Engine

4.7L Engine

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to the applicable warnings and cautions for this system before performing the following operation. Refer to PLUMBING, WARNING  and PLUMBING, CAUTION . Failure to follow these instructions may result in serious or fatal injury.

Fig 1: A/C Liquid Line & Suction Line To A/C Expansion Valve
GC0089601Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Recover the refrigerant from the refrigerant system. Refer to PLUMBING, STANDARD PROCEDURE .
  3. Remove the air filter housing cover and resonator inlet tube. Refer to BODY, AIR CLEANER, REMOVAL, 4.7L .
  4. Remove the nuts (3) that secures the A/C liquid line (1) and the A/C suction line (5) to the A/C expansion valve (2) and to the A/C compressor (4).
  5. Disconnect the A/C suction line and the A/C liquid line from the A/C expansion valve and the A/C compressor.
  6. Separate the A/C liquid line from the A/C suction line and remove and discard the O-ring seals and gaskets.
  7. Install plugs in, or tape over the opened refrigerant line fittings and the expansion valve and compressor ports.
scientia non olet · About LEMON Manuals