Jet, Piston Oil Cooler: Installation: Installation
WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate a new O-ring seal (1) with engine oil and install on the piston oil cooler jet(s).
NOTE:
Piston oil cooler jet for cylinders one/two shown in illustration, piston oil cooler jets for cylinders three/four and five/six are similar.
- Install the piston oil cooler jet(s) (2) into the engine block and tighten the retaining bolt (1) to 6 N.m (53 in. lbs.).
- Install the crankshaft. Refer to CRANKSHAFT, INSTALLATION .
- If removed, install the oil filter and fill the engine crankcase with the proper oil to the correct level. Refer to LUBRICATION/OIL - STANDARD PROCEDURE .
- Fill the cooling system. Refer to STANDARD PROCEDURE .
- Connect the negative battery cable and tighten nut to 5 N.m (45 in. lbs.).
- Run the engine until it reaches normal operating temperature. Check cooling system for correct fluid level. Refer to STANDARD PROCEDURE .