Section 262 (Engine Cooling System - 1500): Engine: Thermostat: Installation: 5.7L

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Thermostat - 5.7L

Courtesy of CHRYSLER GROUP, LLC

Install thermostat (1) (spring side down) into recessed machined groove with bleed valve located at the 12 o'clock position.
Install the thermostat housing (3) bolts. Tighten the bolts to 13 N.m (10 ft. lbs.).

Fig 2: Engine Coolant Temperature Sensor & Thermostat (5.7L)
Courtesy of CHRYSLER GROUP, LLC
Install the radiator hose (1) onto the thermostat housing (3).
Fill the cooling system. Refer to STANDARD PROCEDURE .
Connect the negative battery cable.
Start and warm the engine. Check for leaks. Refer to STANDARD PROCEDURE .