Section 262 (Engine Cooling System - 1500): Engine: Thermostat: Installation: 4.7L
WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - THERMOSTAT HOUSING |
| 2 - THERMOSTAT LOCATION |
| 3 - THERMOSTAT AND GASKET |
| 4 - TIMING CHAIN COVER |
- Clean the mating areas of the timing chain cover (4) and the thermostat housing (1).
- Install the thermostat (3) (spring side down) into the recessed machined groove on the timing chain cover (4).CAUTION:
The housing must be tightened evenly and the thermostat must be centered into the recessed groove in the timimg chain cover. If not, it may result in a cracked housing, damaged timing chain cover threads or coolant leaks.
- Position the thermostat housing (1) on the timing chain cover (4).
- Install the housing-to-timing chain cover bolts. Tighten the bolts to 13 N.m (112 in. lbs.).
- Install the lower radiator hose on the thermostat housing (1).
- Install the splash shield.
- Lower the vehicle.
- Fill the cooling system. Refer to STANDARD PROCEDURE .
- Connect negative battery cable.
- Start and warm the engine. Check for leaks.