Sensor, Coolant Temperature: Removal: 4.7L
WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - ECT SENSOR |
| 2 - MOUNTING BOLTS (2) |
| 3 - MAP SENSOR |
| 4 - INTAKE MANIFOLD |
WARNING:
Hot, pressurized coolant can cause injury by scalding. Cooling system must be patially drained before removing the engine coolant temperature (ECT) sensor.
- Partially drain the cooling system. Refer to STANDARD PROCEDURE .
- Disconnect the electrical connector from the ECT sensor (1).
- Remove the sensor from the intake manifold (4).