Heater, Engine Block: Installation: 4.7L
WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
- Clean and inspect the block heater hole.
- Install the new O-ring seal(s) to heater.
- Insert the block heater (1) into cylinder block and position the element properly.
- With the heater fully seated, tighten center screw to 2 N.m (17 in. lbs.).
- Fill the cooling system with the recommended coolant. Refer to STANDARD PROCEDURE .
- Start and warm the engine.
- Check the block heater for leaks.