Fan, Cooling, Electric: Installation: 4.7L/5.7L
WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
- If removed, install the electric cooling fan resistor. Tighten the mounting screw securely.
- If removed, install the lower fan shroud (1) to the upper fan shroud (2).
- Position the viscous fan (if equipped), radiator fan shroud (1, 2) and electric cooling fan (3) into the vehicle as an assembly.
- Install the electric cooling fan (3) by engaging the electric cooling fan's (3) upper and lower retaining clips to the radiator.
- Install the fan shroud (1, 2) by engaging the fan shroud's (1, 2) lower retaining clips to the radiator/electric cooling fan (3).NOTE:
Make sure all retaining clips lock into place.
- Install the fan shroud (1, 2) mounting bolts (4). Tighten to 10 N.m (89 in. lbs.).
- Connect the electric cooling fan (3) electrical connector.
- If equipped, install the viscous fan assembly. Refer to FAN, COOLING, VISCOUS, INSTALLATION .
- Position the upper radiator seal.
- Install the upper radiator seal plastic rivets (2).
- Install the upper radiator push pins (1).
- Connect the negative battery cable.