Sensor, Manifold Air Pressure (Map): Installation: 4.7L

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Map Sensor O-Ring

Courtesy of CHRYSLER GROUP, LLC

1 - MAP SENSOR

2 - O-RING

Clean MAP sensor mounting hole at intake manifold.
Check MAP sensor o-ring seal (2) for cuts or tears.

Fig 2: Map Sensor Location
Courtesy of CHRYSLER GROUP, LLC
Position MAP sensor into manifold by sliding sensor over locating pin (6).
Install mounting bolt (8). Tighten to 3 N.m (25 in. lbs.).
Connect electrical connector (2).