Sensor, Air Temperature, Intake: Removal: 3.6L

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect and isolate the negative battery cable.
Remove the engine cover.

Fig 1: IAT Sensor Electrical Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect the electrical connector (2) from the inlet air temperature (IAT) sensor.

Fig 2: IAT Sensor Tab/O-Ring
Courtesy of CHRYSLER GROUP, LLC
Clean dirt from the air inlet tube at the IAT sensor base.
Gently lift the small plastic release tab (3), rotate the sensor about 1/4 turn counter-clockwise and remove the sensor from the inlet air hose.
The IAT sensor O-ring (2) can be reused if not damaged.