6.7L Diesel

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Starter 6.7L Diesel

Courtesy of CHRYSLER GROUP, LLC

Install the starter motor. Tighten the three bolts (4) to 43 N.m (32 ft. lbs.).
Connect solenoid wire harness connector (3).
Install the B+ cable (1) onto stud. Tighten nut (2) to 24 N.m (18 ft. lbs.).
Install the B+ cable (1) dust cover.

Fig 2: Left Engine Block Stiffener & Bolts
Courtesy of CHRYSLER GROUP, LLC
If equipped, install the engine block stiffener (1). Tighten bolts (2) to 89 N.m (66 ft. lbs.).
Lower the vehicle.
Connect both negative battery cables.