LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 259 (Starting (Service Information) 1500) >> Starter >> Diagnosis And Testing >> Diagnosis And Testing - Starter Motor >> Starter Solenoid

Starter Solenoid

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Certain vehicles with certain engines may require starter motor removal for the following test.

Fig 1: Solenoid Continuity Test
GC0082803Courtesy of CHRYSLER GROUP, LLC
  1. If necessary, remove starter motor from vehicle. Refer to Starter Motor REMOVAL .
  2. Disconnect solenoid connector wiring from starter motor.
  3. Check for continuity between solenoid terminal (2) and solenoid case (3). There should be continuity. If not OK, replace faulty starter motor assembly.
scientia non olet · About LEMON Manuals