Cover, Seat Cushion, Front: Removal: Removal: Manual

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Seat Back Cover Straps

Courtesy of CHRYSLER GROUP, LLC

Separate the seat back cover straps (2) from under the seat cushion.

Fig 2: Side Shield Screws
Courtesy of CHRYSLER GROUP, LLC
Remove the side shield screws (2) in the back.

Fig 3: Inboard Shield
Courtesy of CHRYSLER GROUP, LLC
Remove the inboard shield screw (1).
Remove the inboard side shield (2).

Fig 4: Door Handle Clip Tool
Courtesy of CHRYSLER GROUP, LLC
Using a door handle clip tool (1) or equivalent, release the clip holding the handle (2) onto the seat and remove the handle.
Using trim stick (special tool #C-4755, Trim Stick) or equivalent, release the seven tabs and separate the center bezel from the outboard side shield.
Pull the bezel rearward and release the front retaining tab.

Fig 5: Outer Side Shield
Courtesy of CHRYSLER GROUP, LLC
Remove the screw (1).
Release the retaining clips (2) and remove the outer side shield.

Fig 6: Recliner Rod
Courtesy of CHRYSLER GROUP, LLC
Separate the clip (1) and separate the recliner rod (2) from the lever.
Remove the push pin fastener (3).

Fig 7: J-Straps
Courtesy of CHRYSLER GROUP, LLC
Separate the cover J-straps (1) from the sides and remove the foam/cover assembly.

Fig 8: Hog Rings
Courtesy of CHRYSLER GROUP, LLC
Remove the 10 hog rings (2) and separate the cover (1) from the foam.