VALVE, Diesel Exhaust Fluid Engine Coolant Control: Installation: Installation

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Coolant Control Valve Assembly

Courtesy of CHRYSLER LLC

Install the coolant control valve assembly (2). Tighten bolt (1) to 54 N.m (40 ft. lbs.) .

Fig 2: Removing/Installing Supply & Return Lines
Courtesy of CHRYSLER LLC
Position and connect the DEF coolant lines (5) into routing clip (6).
Connect the coolant supply (1) and return lines (2) to DEF tank.

Fig 3: Removing/Installing Coolant Control Valve Harness Connector
Courtesy of CHRYSLER LLC
Connect the coolant control valve harness connector (1).

Fig 4: Removing/Installing Bolts
Courtesy of CHRYSLER LLC
Install the DEF tank (2) into place. Tighten bolts (1) to 108 N.m (80 ft. lbs.).
Remove the transmission jack.

Fig 5: Removing/Installing DEF Coolant Lines, Push Pin & Coolant Lines Bracket
Courtesy of CHRYSLER LLC
Clip coolant lines bracket (3) to frame rail and install push pin (4).
Connect the coolant hoses (1 and 2) going to DEF tank.
Fill the cooling system. Refer to Standard Procedure .
Connect both negative battery cables.