Diagnostic Test
WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR BCM CAN BUS DTCS
- With the scan tool, read BCM DTCs.
Are any BCM CAN BUS DTCs present?
Yes
- Refer to DIAGNOSIS AND TESTING and perform the appropriate diagnostic procedure. Perform the diagnostic procedure for DTC U0001-CAN C BUS first.
- Perform the TRANSMISSION VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Go To 2
- With the scan tool, read BCM DTCs.
- CHECK FOR TRANSMISSION DTCS
- With the scan tool, read transmission DTCs.
Are any transmission DTCs present?
Yes
- Refer to DIAGNOSTIC CODE INDEX and perform the appropriate diagnostic procedure.
- Perform the TRANSMISSION VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Using the schematics as a guide, check the Transmission Control Module A (TCMA) terminals for corrosion, damage or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace and program the TCMA in accordance with the Service Information. Refer to VALVE BODY, REMOVAL .
- Perform the TRANSMISSION VERIFICATION TEST. Refer to STANDARD PROCEDURE .
- With the scan tool, read transmission DTCs.