LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 229 (5.7L - DTCS P058C To P1495 - 1500) >> Diagnosis And Testing >> P06EF-Engine Restart Performance >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. DTC IS ACTIVE 
    1. Turn the ignition on.
    2. With the scan tool, erase DTCs in the PCM.
    3. Test drive the vehicle in Start/Stop mode. Make several complete stops, and Auto-Restart attempts.
    4. Turn the ignition on.
    5. With the scan tool, select View DTCs.

      Is the status Active for this DTC?

      Yes 

      • Go To  2

      No 

  2. CHECK THE CONDITION OF THE BATTERY AND STARTER CONNECTIONS 
    1. Turn the ignition off.
    2. Inspect the Battery Cables, Posts and Starter Motor connections for signs of corrosion or a poor connection.

      Were any problems found?

      Yes 

      • Perform the appropriate repair. Refer to appropriate service information.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .

      No 

      • Go To  3
  3. CHECK THE BATTERY 
    1. Using the Battery Charger/Tester, check the condition of the Battery.

      Did the Battery test good?

      Yes 

      • Go To  4

      No 

      • Replace the Battery in accordance with the service information.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  4. CHECK THE FUEL DELIVERY SYSTEM 
    1. Perform the CHECKING THE FUEL DELIVERY SYSTEM diagnostic procedure. Refer to DIAGNOSIS AND TESTING .

      Were any problems found?

      Yes 

      • Perform the appropriate repair. Refer to appropriate service information.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .

      No 

      • Go To  5
  5. CHECK THE ENGINE MECHANICAL SYSTEM 
    1. Perform the CHECKING THE ENGINE MECHANICAL SYSTEM diagnostic procedure. Refer to DIAGNOSIS AND TESTING .

      Were any problems found?

      Yes 

      • Perform the appropriate repair. Refer to appropriate service information.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .

      No 

      • Replace the Starter Motor in accordance with the service information.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals