COOLER and HOSES, Charge Air: Removal: Removal
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - BOLT |
| 2 - CHARGE AIR COOLER |
| 3 - CLAMP |
| 4 - BOOST TUBE |
WARNING:
IF THE ENGINE WAS JUST TURNED OFF, THE AIR INTAKE SYSTEM TUBES MAY BE HOT.
- Disconnect the battery negative cables.
- Discharge the A/C system and remove the A/C condenser (if equipped). Refer to Plumbing, Standard Procedure and CONDENSER, A/C, Removal .
- Remove the front grille assembly. Refer to GRILLE, Removal .
- Remove the transmission auxiliary cooler. Refer to COOLER, Transmission Oil, Removal .
- Remove the intake air tubing (4) from the charge air cooler (2).
- Remove the charge air cooler bolts. Pivot the charge air cooler (2) forward and up to remove.