LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 208 ((Transmission Control Module (TCM) - Electrical Diagnostics - As68RC Automatic Transmission)) >> DTC Troubleshooting >> P2806-Transmission Range Sensor Alignment >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

When Monitored:

Set Condition:



  1. CHECK FOR OTHER DTCS 
    NOTE:

    This DTC is supplemental and requires no diagnostic troubleshooting. Typically, if this code is set without P0706, P0707, or P0708 it is caused by the column shifter placement between gate stop positions, positioning the gear range indicator switch between gear positions for more than 2 seconds. Only diagnose the range sensor as instructed in P0706, P0707, or P0708 if they are present.

    Are there any other TRS DTCs set?

    Yes 

    No