LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (4.7L Engine (Service Information)) >> Cylinder Head >> COVER(S), Cylinder Head >> Removal >> Right Side

Right Side

WARNING: This page is about a different car, the 2011 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: IGNITION COIL - 4.7L
GC0082845Courtesy of CHRYSLER LLC
  1. Disconnect battery negative cable.
  2. Remove air cleaner assembly, resonator assembly and air inlet hose.
  3. Drain cooling system. Refer to Standard Procedure .
  4. Remove accessory drive belt. Refer to BELT, Serpentine , Removal .
  5. Remove air conditioning compressor retaining bolts and move compressor to the left.
  6. Remove heater hoses.
  7. Disconnect and remove positive crankcase ventilation (PCV) hose.
  8. Remove oil fill tube.
  9. Remove spark plug wires (3).
  10. Remove right rear breather tube and filter assembly.
  11. Remove cylinder head cover retaining bolts.
  12. Remove cylinder head cover.
NOTE:

The gasket may be used again, provided no cuts, tears, or deformation has occurred.

scientia non olet · About LEMON Manuals