ACTUATOR, Stabilizer Bar: Installation: Installation
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
The disconnecting stabilizer bar unit (3) is not serviced separately from the bar (4). Do not disassemble this unit from the stabilizer bar.
- Install the actuator (1) to the disconnecting unit (3) and tighten the bolts (2) to specifications. Refer to SPECIFICATIONS . NOTE:
The seal must be clean and intact in the electrical connector when reconnecting to the actuator (1).
- Reconnect the electronic actuator electrical connector for the disconnecting stabilizer bar.
- Remove the supports and lower the vehicle.
- Using a scan tool program the new stabilizer bar to the vehicle.