Torque Specifications
WARNING: This page is about a different car, the 2011 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. |
|---|---|---|---|
| BOLT - CAMSHAFT | |||
| Non - Oiled Sprocket Bolt | 122 | 90 | - |
| Bearing Cap Bolts | 11 | - | 100 |
| Bolt - Counterbalance shaft retaining | 28 | - | 250 |
| Bolts - Timing Chain Cover | 58 | 43 | - |
| Bolts - Connecting Rod Cap | 27 | 20 | - |
| Plus 90° Turn | |||
| Bolts - Bed Plate | Refer to INSTALLATION Procedure. | ||
| Bolt - Crankshaft Damper | 175 | 130 | - |
| BOLTS - CYLINDER HEAD | |||
| M11 Bolts | Refer to left cylinder head INSTALLATION or right cylinder head INSTALLATION Procedure | ||
| M8 Bolts | Refer to left cylinder head INSTALLATION or right cylinder head INSTALLATION Procedure | ||
| Bolts - Cylinder Head Cover | 12 | - | 105 |
| Bolts - Exhaust Manifold | 25 | 18 | - |
| Nuts- Exhaust Manifold Heat Shield | 8 | - | 72 |
| Then loosen 45° | |||
| Bolts - Flexplate | 95 | 70 | - |
| Bolts - Engine Mount Bracket to Block | 61 | 45 | - |
| Bolts - Rear Mount to Transmission | 46 | 34 | - |
| BOLTS - GENERATOR MOUNTING | |||
| M10 Bolts | 54 | 40 | - |
| M8 Bolts | 28 | - | 250 |
| Bolts - Intake Manifold | 12 | - | 105 |
| Refer to INSTALLATION Procedure for Tightening Sequence | |||
| Bolts - Oil Pan | 15 | - | 130 |
| Plug - Oil Pan-Drain | 34 | 25 | - |
| Bolts - Oil Pump | 28 | - | 250 |
| Bolts - Oil Pump Cover | 12 | - | 105 |
| Bolt and Nut - Oil Pickup Tube | 28 | - | 250 |
| Bolt - Oil Dipstick Tube to Engine Block | 15 | - | 130 |
| Bolts - Oil Fill Tube | 12 | - | 105 |
| Bolts - Timing Chain Guide | 28 | - | 250 |
| Timing Chain Tensioner Arm | 28 | - | 250 |
| Bolts - Hydraulic Tensioner | 28 | - | 250 |
| Bolts - Timing Chain Primary Tensioner | 28 | - | 250 |
| Bolt - Timing Drive Idler Sprocket | 34 | 25 | - |
| Bolts - Thermostat Housing | 12 | - | 105 |
| Bolts - Water Pump | 58 | 43 | - |