LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 172 (As68RC Automatic Transmission (Service Information)) >> Sensor, Speed >> Removal >> Input Speed Sensor

Input Speed Sensor

WARNING: This page is about a different car, the 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Input Speed Sensor
GC0109578Courtesy of CHRYSLER GROUP, LLC
  1. Raise and support the vehicle.
  2. Place a suitable fluid catch pan under the transmission.
  3. Remove the wiring connector from the input speed sensor.
  4. Remove the bolt holding the input speed sensor to the transmission case.
  5. Remove the input speed sensor from the transmission case.
scientia non olet · About LEMON Manuals