Seal, Axle Drive Shaft: Installation: Left: Notes
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The differential and the right axle seal must be removed to replace the left axle seal.
- Install a new seal onto (special tool #8885, Installer, Axle Seal) (3) puck and place it in position.
- Install (special tool #5058A, Compressor, Spring) threaded rod (1) through the axle tube.
- Install (special tool #8411, Installer, Seal) (2) behind the seal and 8885 installer.
- From the outer axle tube, thread 5058-A until the left axle seal is seated.