LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1623 (Horn System - (Service Information) - 2500 Hd) >> Horn >> Removal

Section 1623 (Horn System - (Service Information) - 2500 Hd): Horn: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0154498Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative cable from the battery.
  2. Remove the left front fender wheel house splash shield from the vehicle. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL .
  3. Locate the horns and mounting bracket (1) on the outboard side of the left front fender load beam (4) above the left front fender wheel house.
  4. Disconnect the headlamp and dash wire harness connector for the horns (2) from the horn connector at the back of the rearward horn.
  5. Remove the screw (3) that secures the horn mounting bracket to the load beam.
  6. Remove the horns and mounting bracket from the load beam as a unit.
scientia non olet · About LEMON Manuals