Sensor, Speed, Input: Installation: Installation
WARNING: This page is about a different car, the 2012 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - OUTPUT SPEED SENSOR |
| 2 - LINE PRESSURE SENSOR |
| 3 - INPUT SPEED SENSOR |
- Install the input speed sensor (3) into the transmission case. Refer to Fig 1.
- Install the bolt to hold the input speed sensor (3) into the transmission case. Tighten the bolt to 12 N.m (105 in.lbs.).
- Install the wiring connector onto the input speed sensor.
- Verify the transmission fluid level. Add fluid as necessary.
- Lower vehicle.