LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1616 ((Powertrain Control Module (Pcm) - Electrical Diagnostics - 68RFE Automatic Transmission - 2500 Hd)) >> DTC Troubleshooting >> P0884-Power Up At Speed >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

CHECK PCM HARNESS CONNECTIONS 

NOTE:

This DTC is set when the Transmission portion of the Powertrain Control Module is initialized while the vehicle is moving in a valid forward gear.

  1. With the scan tool, read and record the Event and Environmental Data.
  2. Disconnect all PCM harness connectors.
  3. Disconnect all related in-line harness connections (if equipped).
  4. Disconnect the related Power Distribution Center (PDC) harness connectors.
  5. Inspect harness connectors, component connectors, and all male and female terminals for the following conditions:
    • Proper connector installation.
    • Damaged connector locks.
    • Corrosion.
    • Other signs of water intrusion.
    • Weather seal damage (if equipped).
    • Bent terminals.
    • Overheating due to a poor connection (terminal may be discolored due to excessive current draw).
    • Terminals that have been pushed back into the connector cavity.
    • Perform a terminal drag test on each connector terminal to verify proper terminal tension.
    • Check all of the Fused B (+), Fused Ignition Switch Output and ground circuits to the PCM for an intermittent open or short to ground.

    Repair any conditions that are found.

  6. Reconnect all PCM harness connectors. Be certain that all harness connectors are fully seated and the connector locks are fully engaged.
  7. Reconnect all in-line harness connectors (if equipped). Be certain that all connectors are fully seated and the connector locks are fully engaged.
  8. Reconnect all PDC component harness connectors. Be certain that all connectors are fully seated and the connector locks are fully engaged.
  9. With the scan tool, erase DTCs.
  10. Using the recorded Event and Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
  11. With the scan tool, read PCM DTCs.

    Did the DTC return?

    Yes 

    No 

scientia non olet · About LEMON Manuals